Sizing

Here are the standard sizes of our products. If you didn’t find a suitable size or you need personalize some part of item (for example, make a browband loose and etc.) – just write it in the comments of your order and we sew item according to your measurements. Wideness of items also can be customized by request.

Classic dog collars

All dogs are different and vary in their size. Here is a general guideline to fit your dog appropriately for a dog collar. For a proper fit, measure your dog’s neck with a cloth seamstress tape measure.

– Pull the tape snug but not tight where the collar would normally sit;
– Add 3-4 cm (1,5 – 2″) to this length. It is your dogs neck size.
– Choose the size, where this length is approximately in the middle hole of the collar.

If you need custom size. Measure your dog’s neck, add 3-4 cm. And write in the comments to the order: “I need a collar [the resulting length] to the middle hole.”

For example, your dog’s neck circumference is 33 cm. Add another 4 cm. 37 cm is approximately the middle hole in a size S collar. This means you need size S. If your dog is still growing or covered with thick fur in winter, choose a size where the desired length is closer to the first hole.

Martingale collar

– Pull the tape snug but not tight  where the collar would normally sit, add 3-4 cm (1,5 – 2″) to this length (B);
– Now you need to measure a head size (A). Measure he widest area of your dog’s head. Usually just in front or behind its ears.

A correctly selected martingale collar must be able to slip over the dog’s head, but not slip back over when the small ring is taught. So the right size of the martingale collar (the length of the big loop) will be the circumference of the head minus 1\2 of your dog’s skull width.

If you need custom size. Measure your dog’s neck, add 3-4 cm and subtract 1\2 length of your dog’s skull width. Than write in the comments to the order: “I need a collar [“the resulting length”] for “B.” By default “A” is 10cm long, but can be changes by request

Leads and lead coupler

Leads:

S – 1m
M – 1.5m

The wide of the straps is 1.8cm.

Lead coupler:

One size: from 35cm to 75cm

The wide of the straps is 1.8cm.

Harnesses

Use the measurements below to help you choose the right harness. Girth is measured by the widest part of your dog’s chest. Neck is measured around widest part of the neck. The wide of the straps is 2,5cm.

Harness Classic

Horse bridle, cavesson, show halters

Take the measurements around the horses head, to the same point on the other side (D), for the noseband (A), cheakpiece split to split (B), throatlash (C) and browband (E).  Here you can check all details about how to measure and fit the bridle correctly.

Horse halter, hackamore

Take the measurements around the horses head, to the same point on the other side (C), for the noseband (A), cheakpiece split to split (B).

Breastplate